What parts are found in an electric generator? Select 4 options.an armaturea batterya permanent magnetan electromagnetbrushesslip rings
The diagram shows a negative charge moving in a magnetic field.

Four compasses are placed around a wire, as shown.The wire is then connected to a battery so that a current flows down the wire.How will the compasses point once the current is flowing?





Which component is found only in electric generators and not in electric motors?
A magnetically soft material is placed in a strong magnetic field.
How does an electric motor use magnetic force to produce motion?
Two bar magnets are labeled A and B. The ends of each magnet are numbered 1 or 2, but the poles are not labeled. When A1 is brought near B1, the bars repel.
brushtransformercommutatorarmature
Which change will cause an increase in the electric current produced through electromagnetic induction?
Tonya is modeling the discovery of electromagnetic induction. Which procedure should she use?
The magnetic field 0.02 m from a wire is 0.1 T. What is the magnitude of the magnetic field 0.01 m from the same wire?
Which is the best procedure to make a permanent magnet?
Which describes the magnetic field that forms when a wire carries an electric current?
A point charge of 5.0 × 10–7 C moves to the right at 2.6 × 105 m/s in a magnetic field that is directed into the screen and has a field strength of 1.8 × 10–2 T.
Which actions most likely cause the domains within a material to lose their alignment and become more randomized? Check all that apply.heating the materialrubbing the material against a magnetpassing electricity around the materialplacing the material in a magnetic field of opposite polarityplacing the material near a strong magnethitting the material
When using the right-hand rule to determine the direction of the magnetic force on a charge, which part of the hand points in the direction of the magnetic field?
Which changes will cause an increase in the magnetic field of a solenoid? Check all that apply.using more wire loopsusing fewer wire loopsusing a larger currentusing a smaller currentincreasing the spacing between loopsdecreasing the spacing between loops
The diagram shows two bar magnets. They are cut along the dashed line, and then the two marked ends are placed near each other.
The strength of a magnetic field around a wire carrying a current of 20 A is 0.004 T. What is the strength of the magnetic field if the current is changed to 40 A?
Which device converts electrical energy into kinetic energy?
Did you find these answers helpful?